Karmann Ghia Camshaft Parts

Push Rod Tube, One
200 mm
For 40 HP Engines

VW Beetle 1961-65
VW Bus 1960-65
VW Karmann Ghia 1961-66

Individual Push Rod Tube Seals, Set of 16 These seals go around the push rod tubes. On Bugs and Buses up to 1971, the heads have to come off to replace the seals. We highly recommend you replace the tubes at this time as well. If you don't they will usually leak even though you have new seals. One car requires 16 seals. We sell the seals separately or as a set of 16.

These push rod seals fit the following cars:

VW Beetle and VW Super Beetle 1961-1979
VW Karmann Ghia 1961-1974
VW Type 3 1962-1973
VW Thing 1973-1974
VW Bus 1963-71

Push Rod Tube Set
8 Push Rods
All 1300-1600cc Engines

 

VW Beetle and VW Super Beetle 1966-1979
VW Karmann Ghia 1966-1974
VW Bus 1964-1971
VW Type 3 1962-1973
VW Thing 1973-1974

We highly recommend that you replace these whenever you pull the heads off a 1300 through a 1600 engine. The stock tubes have a crush built into each end. If you try to stretch the old ones they will revert back to where they were crushed when they heat up. Most likely, they'll also leak. One car requires 8 tubes.

Push Rod Tube
All 1300-1600cc Engines

 

VW Beetle and VW Super Beetle 1966-1979
VW Karmann Ghia 1966-1974
VW Bus 1964-1971
VW Type 3 1962-1973
VW Thing 1973-1974

We highly recommend that you replace these whenever you pull the heads off a 1300 through a 1600 engine. The stock tubes have a crush built into each end. If you try to stretch the old ones they will revert back to where they were crushed when they heat up. Most likely, they'll also leak. One car requires 8 tubes.

Camshaft STD (Flat)
This is a 3 rivet camshaft.

VW Beetle 1961-70
VW Bus 1960-70
VW Type-3 1962-70
VW Karmann Ghia 1961-70

Camshaft with Flat Gear
+ 2

VW Beetle 1961-71
VW Bus 1960-71
VW Type 3 1962-71
VW Karmann Ghia 1961-71