Karmann Ghia Chassis & Suspension Parts

Also: Boot for Emergency Brake Cable at Chassis for Bus

Clutch Boot For:
VW Beetle and VW Super Beetle 50-79
VW Karmann Ghia 56-74
VW Bus 50-79 Two required
VW Thing 73-74
VW Type 3 62-67

Emergency Brake Cable For:
VW Bus 60-79 From vin#614456

The clutch cable boot holds and seals the guide tube
for the clutch and accelerator cables. Increases the life
expectancy of the cables. Similar function for brake cable.

VW Beetle and VW Super Beetle 1961-79
VW Karmann Ghia 1961-74
VW Thing 1973-74
VW Type 3 1961-74

For VW Beetle 50-68
VW Bus 50-67
VW Karmann Ghia 56-68
VW Type 3 62-68
VW WEstfalia Camper 55-67

Shock:
VW Beetle 10/52-4/59 Rear Upper and Lower
VW Bus 50-67 Rear Lower and 63-67 Front Upper
VW Karmann Ghia 56-5/59 Upper and Lower

Axle Beam
VW Standard Beetle 50-77
VW Karmann Ghia 56-74
VW Thing 73-74

VW Beetle and VW Super Beetle 67-79
VW Karmann Ghia 67-74
VW Type 3 67-73
VW Thing 73-74

This valve installs under the main conduit, draining out moisture while
preventing moisture from getting in toward the floor pan.
 

VW Beetle 50-65
VW Karmann Ghia 56-65

This seal installs behing the tunnel inspection plate at the chassis framehead.
prevents debris from entering the inspection tunnel.

VW Beetle and VW Super Beetle 50-79
VW Karmann Ghia 56-74
VW Type 3 62-73
VW Thing 73-74

VW Beetle 50-68
VW Karmann Ghia 56-68
VW Bus 50-67
VW Type 3 62-68

VW Beetle 49-67
VW Karmann Ghia 56-67
VW Bus 50-67
VW Type 3 62-67

Two or more may be required for each side. These seal and adjust clearance
of the axle tube. Adding gaskets increases clearance and loosens axle tube..
 

VW Beetle (Standards) 50-77
VW Karmann Ghia 56-74
VW Thing 73-74

Install between the body and the front axle beam to prevent vibration

VW Beetle 50-59
VW Karmann Ghia 56-59

These install into the rear torsion housing on the sides of the spring plate.
They hold the plate in the torsion housing; one on left, one on right side of car
and the other two inside the spring plate cap. (The cap is bolted
over the spring plate/torsion housing.)
 

VW Beetle 1960-68
VW Karmann Ghia 1960-68
VW Type 3 61-68

These install into the rear torsion housing on the sides of the spring plate.
They hold the plate in the torsion housing; one on left, one on right side of car
and the other two inside the spring plate cap. (The cap is bolted
over the spring plate/torsion housing.)

Recommended for all models.

VW Beetle 1950-1968
VW Karmann Ghia 1956-68
VW Bus 1950-63 up to chassis 1144281

VW Beetle Convertible 1966-70
VW Beetle Sedan 1966-77
VW Karmann Ghia 1966-74