Karmann Ghia Flywheel and Parts

« Back to Karmann Ghia Catalog
Have a question? Talk to us!

Hardware

Hardware

Flywheel Dowell Pin, 14 X 8
One Pin

VW Beetle and VW Super Beetle 61-79
VW Karmann Ghia 61-74
VW Bus 60-71
VW Type 3 62-73
VW Thing 73-74

Karmann Ghia
$0.89
Part #: 113-105-277
Flywheel Gland Nut Washer

VW Beetle and VW Super Beetle 46-79
VW Bus 50-71
VW Karmann Ghia 56-74
VW Type 3 62-73
VW Thing 73-74

Karmann Ghia
$1.95
Part #: 111-105-297
Flywheel Gland Nut. With felt seal and pilot bearing

VW Beetle and VW Super Beetle 61-79
VW Karmann Ghia 61-74
VW Bus 60-71
VW Type 3 62-73
VW Thing 73-74

Karmann Ghia
$14.95
Part #: 111-105-305E


Bearings

Bearings

Transmission Input Shaft Pilot Bearing (In Gland Nut)

When installed on 1200-1600cc engines, this part is inside the gland nut. On T4 engines it's in the flywheel/crank. This centers the input shaft on the transmission. Noise when clutch depressed is the clue that tells you it's bad. This part is ONLY used on standard transmission engines.

If you have a Type 1 and are ordering a gland nut, you do NOT need to order this, as replacement gland nuts come with a pilot bearing already installed.

Karmann Ghia
$8.95
Part #: 111-105-313A


Flywheel

Flywheel

Chromoly Flywheel 200mm 8 Dowel, Lightened
Forged reproduction

VW Beetle and VW Super Beetle 67-79
VW Karmann Ghia 67-74
VW Bus 63-71
VW Type 3 67-73

This chromoly version of our lightened flywheel is the answer for anyone looking for the ultimate in durability under extreme conditions. One piece chromoly construction and offset 8-dowel hole pattern along with a weight of approximately 13 lbs., make this fully balanced flywheel the best option for a high performance engine. 12-Volt 200mm (130 teeth) O-ring style.
Karmann Ghia
$169.95
Part #: 00-4099-0
Flywheel 200mm 8 Dowel, Lightened
Finely cast reproduction

VW Beetle and VW Super Beetle 67-79
VW Karmann Ghia 67-74
VW Bus 63-71
VW Type 3 67-73

Karmann Ghia
$89.95
Part #: 311-105-271L
Flywheel 200mm
4 Dowel Pin
Finely cast reproduction

VW Beetle and VW Super Beetle 67-79
VW Karmann Ghia 67-74
VW Bus 63-71
VW Type 3 67-73

Karmann Ghia
$84.95
Part #: 311-105-273A


Flywheel Parts

Flywheel Parts

Flywheel O-Ring

VW Beetle and VW Super Beetle 66-79
VW Karmann Ghia 67-74
VW Bus 64-71
VW Type 3 64-73

Karmann Ghia
$0.69
Part #: 113-105-295A
Flywheel shim: .24mm

VW Beetle and VW Super Beetle 66-79
VW Karmann Ghia 67-74
VW Bus 64-71
VW Type 3 64-73

Karmann Ghia
$2.39
Part #: 113-105-281A
Flywheel Bearing Felt Seal

VW Beetle and VW Super Beetle 50-79
VW Karmann Ghia 61-74
VW Bus 72-79
VW Type 3 66-73
Karmann Ghia
$0.79
Part #: 111-105-311
Flywheel shim: .30mm

VW Beetle and VW Super Beetle 66-79
VW Karmann Ghia 67-74
VW Bus 64-71
VW Type 3 64-73

Karmann Ghia
$2.39
Part #: 113-105-283A
Flywheel shim: .34mm

VW Beetle and VW Super Beetle 66-79
VW Karmann Ghia 67-74
VW Bus 64-71
VW Type 3 64-73

Karmann Ghia
$2.39
Part #: 113-105-287A
Flywheel shim: .36mm

VW Beetle and VW Super Beetle 66-79
VW Karmann Ghia 67-74
VW Bus 64-71
VW Type 3 64-73

Karmann Ghia
$2.39
Part #: 113-105-289A
Flywheel shim: .38mm

VW Beetle and VW Super Beetle 66-79
VW Karmann Ghia 67-74
VW Bus 64-71
VW Type 3 64-73

Karmann Ghia
$2.39
Part #: 113-105-291A
Rear Main Flywheel Seal
high quality silicone

VW Beetle and VW Super Beetle 61-79
VW Karmann Ghia 61-74
VW Bus 61-71
VW Type 3 (Squareback, Fastback, Notchback) 67-73

Karmann Ghia
$4.69
Part #: 113-105-245FG


General

General

Deluxe Flywheel Main Seal Tool For Vw Bug / Vw Beetle 1600CC Based Air-cooled Engines. Provides Proper And Even Pressure On The Flywheel Main Seal During Install.
Karmann Ghia
$32.95
Part #: 5774
Helping Hand Gland Nut And Axle Nut Assist Tool For Classic Vw Bug / Volkswagen Beetle. Helps Tighten Or Loosen Hi-Torqued Volkswagen Bug Axle Nuts And Gland Nuts By Holding The Brake Drum Or Flywheel Steady. Works With 6 Volt And 12 Volt Flywheels. Works With Vw 4 X 130mm Lug Bolt Pattern And Vw 5 X 205mm Lug Bolt Pattern Brake Drums/Rotors.
Karmann Ghia
$37.95
Part #: 5750
VW Crank & Flywheel Jig 8 Pin Positioning Tool mounts to the flywheel or crankshaft and aligns them for drilling 4 additional dowel pin holes. The jig includes hardware to mount to either the crank or the flywheel to ensure a proper pattern is drilled. The jig can be used on all 200mm flywheels and 1300cc and larger Type 1 based cranks.
Karmann Ghia
$32.95
Part #: 5004


Printer friendly


Continue Shopping
Karman Ghia parts for the following years: 1956, 1957, 1958, 1959, 1960, 1961, 1962, 1963, 1964, 1965, 1966, 1967, 1968, 1969, 1970, 1971, 1972, 1973 and 1974